Wed, 18 Nov 2026 19:22:23 UTC Log in
Generic data test program 15.07 MB built 2026-10-13 16:23:22 GMT

Description

dt is a generic data test program used to verify proper operation of peripherals, file systems, device drivers, or any data stream supported by the operating system. In its' simplest mode of operation, dt writes and then verifies its' default data pattern, then displays performance statistics and other test parameters before exiting. Since verification of data is performed, dt can be thought of as a generic diagnostic tool. dt command lines are similar to the dd program, which is popular on most UNIX systems. It contains numerous options to give the user control of various test parameters. dt has been used to successfully test disks, tapes, serial lines, parallel lines, pipes, and memory mapped files. In fact, dt can be used for any device that allows the standard open, read, write, and close system calls. Special support is necessary for some devices, such as serial lines, for setting up the speed, parity, data bits, etc. Available documentation is located in /usr/share/doc/dt. Sample scripts and config data are installed in /usr/share/dt.

Dependencies

6 total
Requires5
  • gcc
  • libuuid-devel
  • make
  • rpmlib(CompressedFileNames) <= 3.0.4-1
  • rpmlib(FileDigests) <= 4.6.0-1
Provides1
  • dt = 26-2.fc45
ObsoletesNo Obsoletes
ConflictsNo Conflicts
RecommendsNo Recommends
SuggestsNo Suggests
SupplementsNo Supplements
EnhancesNo Enhances

Files

2
Name ascending sort Size
dt-dt.v26.tar.gz 15.11 MB
dt.spec 7.96 KB
Files 1–2 of 2

Component of

buildroots that installed this RPM

No Buildroots